Teleflex Steering Rack and Cable Assembly

The Teleflex SSC124 series is the replacement steering rack and cable for 1984 – 1996 era rack and pinion steering systems. NOTE:

• This assembly does not fit the new style, “Back Mount ” steering systems.
• Assembly includes rack and cable only.

Measure Steering Cables Instructions:

Replacement of Existing Cable: Locate the part number which is stamped on the plastic jacket of the old cable. If you removed the old cable, measure for the replacement cable as follows:

Instructions For Rack Steering Cable Replacement: Measure plastic cable jacket (Y dimension shown in above drawing) in inches, add 30, and round up to the next foot. Order that length cable.

New Installation: Measure cable routing path from wheel center line to engine connection, as follows:

A = Center line of wheel to gunwale (or deck, if routed downward)

B = Dash to transom

C = Gunwale to centerline of cable connection at centered tiller.

For Cable Installations through the Engine Tilt Tube: Add A, B & C + 6, then round up to the next foot. Order that length cable.

For Cables Mounted to Transom, Splashwell or Stringer: Add A, B & C, then subtract 6 and round up to the next foot. Order that length cable.

TYPICAL SINGLE STATION ROUTING

This diagram shows a single-cable, starboard drive push-pull mechanical cable system. For different systems, please contact Dometic (Mechanical) Technical Service at (610)-495-7011 or www.dometic.com

Cable routings (such as those found on pontoon boats) may vary from the routing pictured. If so, use an alternate method to confirm length by laying a garden hose or similar object) along the cable path and measure run from wheel to engine connection point.

California Residents:
WARNING
Cancer and Reproductive Harm –
P65Warnings.ca.gov